Emm-labs DAC8 MKIV Bedienungsanleitung

ADC8 Mk IVDAC8 Mk IVUSER MANUAL V1.3

9

10OPTIC / WIRE: Selects the physical connector for input data (optical or WIRE). For the WIRE selection an additional switch is necessary to define WI

11Basic OperationIn addition to the basic conversion modes shown below, the DAC8 Mk IV converts between DSD on optical and DSD on BNC (RAW DSD or SDIF

12Conversion from PCM on BNC (SDIF-2) to AnalogAdditional selections for 44.1 / 48 / 88.2 / 96kHz sample rate and for the 64/128 oversampling ratio ca

13Additional selection for RAW DSD or SDIF-3 format for DSD input can be made with the interface format switch. The overampling switch needs to be set

14Conversion from PCM on AES/EBU to DSD on BNC (RAW DSD or SDIF-2) and OpticalOnly 44.1kHz based PCM can be converted to DSD. Additional selections ca

1A/D Converter ADC8 Mk IVThe EMM Labs 8-channel A/D converter is a 4th generation design to meet the highest standards in professional audio recording

2Signal flowNote: Analog inputs are balanced with pin 2 hot, pin 3 cold and pin 1 GND. For unbalanced inputs just connect to pin 2 and tie pin 3 to GN

3

4Digital Audio Input SectionOUT / IN: OUT position selects conversion from analog to digital. IN position selects conversion from digital to digital.

5Table 1: Functional Modes of A/DBasic OperationIn addition to the basic conversion modes shown below, the ADC8 Mk IV converts between DSD on optical

6• DSD format on BNC connectors RAW DSD / SDIF-3Conversion from DSD to PCM“Empty” switch positions are ignored.DSD input can be on BNC or optical conn

7D/A Converter DAC8 Mk IVThe EMM Labs 8-channel D/A converter is a 4th generation design to meet the highest standards in professional audio recording

8Signal FlowNote: *SDIF2 inputs expect 24-bits (or 0-filled 16 bits) of PCMNote: Analog outputs are balanced with pin 2 hot, pin 3 cold and pin 1 GND.